Views: 0 Author: Site Editor Publish Time: 2021-01-23 Origin: Site
cleanPrimary filterNotesWhat？The editor of Shandong snyli Purification will tell you in detail below.：
1.If it is used for a long time without cleaning, the cooling effect will gradually weaken and bacteria will take advantage of the opportunity. In order to avoid this phenomenon, the filter should be cleaned many times to ensure that while improving the cooling effect, it can also extend its service life.
2.If you find that the filter is too dirty, you can wash it with warm water, dry it with equipment, or dry it in the air, but not hot water.
3.Wipe the air conditioner circuit frequently. The wiping cloth must be soft and dry; do not use excessively high temperature hot water when cleaning outdoors, otherwise it will cause deformation, discoloration or short circuit of the air conditioner; do not use chemical cleaners to clean it. Corrosion and deformation of air conditioners occur.
4.Rinse the primary filter with clean water. If the filter has a lot of dust, tap the filter to remove the dust on the surface of the filter. You can also use a brush and a neutral detergent to clean it. Remember not to use acidic detergents and high-temperature hot water. Bake to avoid deformation or discoloration of the primary filter. When cleaning the stainless steel wire mesh on the primary filter, be careful not to damage or deform it, otherwise, after the filter is installed, the purity of the filter material will be unqualified, and the compressor, pump, instrument and other equipment It will be damaged.
5.After cleaning, gently squeeze out the water and dry in a clean, ventilated and cool place. When cleaning the primary filter, the dust scattered in the equipment should be clean, and the inside of the equipment should be cleaned with a damp cloth, especially the filter frame and related parts. Check whether the filter is damaged. If the surface of the filter is loose or hollow, the stainless steel wire mesh on the filter is damaged and deformed. Replace with a new one.
6.Finally, slowly install the primary effect filter and compress it with a compression spring. Make it immobile and shake it. It should be noted that the cleaning of the primary filter is generally1-2Clean once a month. However, the use of primary filters in dusty environments must be specifically decided.