In the process of using the wind chamber, it is sometimes encountered in the wind. The following points are several cases often encountered by daily customers, and the reference can be referred to (1) first check the power switch and Whether the emergency stop switch is on state, if two reasons are not, check the circuit and the leakage switch is closed. (2) Whether the FUSE fuse configured by the IC board is blown, such as the fuse of the fuse, the 4A fuse is required. (3) Check if the micro switch and the photoelectric switch move, if there is no action, the micro switch and photoelectric switch should be replaced. (4) If the AC contactor does not work, it affects the blow, and the AC contactor is required. (5) If the circuit board cannot output a signal in an AC contactor coil, it is necessary to change the IC circuit board. (6) When the wind shower is blowing, it is not allowed to force the door. If the emergency situation is encountered, the shutdown can be turned off. After more than ten years of industry experience, the new environment is always

The application of clean technology has experienced the development of more than half a century, and its application range is increasingly wide and technical requirements are more complicated. Currently, its representative application is the microelectronics industry, medical and health and electronic industries. Its application areas: 01. Microelectronics industry 02. Semiconductor manufacturing 03. Pharmaceutical industry 04. Optical industry 05. Biotechnology Industry 06. Pure chemical reagent manufacturing 07. Micromechanical processing industry 08. Hospital and other health care institutions 09. Production and Packaging Industry of Medical Devices and Transplanting Devices 10. Food & Beverage Industry 1. Microelectronics Industrial Microelectronics Industry is currently the highest in the clean room. The development of large-scale and large-scale integrated circuits (LSI, VLSI) is increasingly high. In the integrated circuit manufacturing process, the larger the integration, the finer the graphic size (represented by the line width), the smaller the size of the cleansing chamber control particle size (

The wind shower room is necessary for people to enter the clean room. It can reduce the pollution problems brought by people into the clean room, reducing the large number of dust particles brought by people / goods from the entrance to the clean room. \"Pneumatic chamber \" can reduce the number of air pollution particles. What are the use and management of the wind chamber? Xinli Purified Xiaobian gives you a specific explanation: 1. Objective: To keep the safety of wind goes, maintain cleanroom environment cleanliness.

The clean air blown out of the air shower can remove dust carried by people, and can effectively block or reduce the dust source from entering the clean area. At the same time, the two doors of the air shower room are electronically interlocked, which can act as an air lock to prevent unpurified air from entering the clean area. It is a highly versatile local purification equipment. The air shower room is generally installed between the clean area and the non-clean area, as a passage between the clean room and the non-clean room.

Air showerWhat should I pay attention to when maintaining?Below byXiaobian of Shandong snyli PurificationDetails to youIntroduction-Air showerseveralMaintenance method：1. Regularly use the instrument to determine the technical indicators of the equipment, and if it does not meet the technical parame