In the process of using the wind chamber, it is sometimes encountered in the wind. The following points are several cases often encountered by daily customers, and the reference can be referred to (1) first check the power switch and Whether the emergency stop switch is on state, if two reasons are not, check the circuit and the leakage switch is closed. (2) Whether the FUSE fuse configured by the IC board is blown, such as the fuse of the fuse, the 4A fuse is required. (3) Check if the micro switch and the photoelectric switch move, if there is no action, the micro switch and photoelectric switch should be replaced. (4) If the AC contactor does not work, it affects the blow, and the AC contactor is required. (5) If the circuit board cannot output a signal in an AC contactor coil, it is necessary to change the IC circuit board. (6) When the wind shower is blowing, it is not allowed to force the door. If the emergency situation is encountered, the shutdown can be turned off. After more than ten years of industry experience, the new environment is always
Clean work shed is a simple clean room for fast and convenient, clean work sheds with a variety of clean levels and space matching, and can be made according to the use requirements, so it is easy to use elastic installation easy and short-moving short and movable Its main feature, clean work sheds can also reduce costs for localization of high cleanrooms in the normal level of clean room to reduce costs.
The wind shower room is necessary for people to enter the clean room. It can reduce the pollution problems brought by people into the clean room, reducing the large number of dust particles brought by people / goods from the entrance to the clean room. \"Pneumatic chamber \" can reduce the number of air pollution particles. What are the use and management of the wind chamber? Xinli Purified Xiaobian gives you a specific explanation: 1. Objective: To keep the safety of wind goes, maintain cleanroom environment cleanliness.
The personnel closing channels entering the production area of clean workshops should set corresponding elsewear facilities according to the production properties, product characteristics, product requirements, etc., and rationally design air flow tissue, set differential pressure and monitoring equipment to meet dust-free The requirements of the workshop on purifying clothes. Factors that need to be considered 1. The settings between the cloak room will be separated by the different stages of the dress, such as switching shoes (take off the whole clothes), wear clean clothes (wear aseptic underwear, sterile coat)
The clean air blown out of the air shower can remove dust carried by people, and can effectively block or reduce the dust source from entering the clean area. At the same time, the two doors of the air shower room are electronically interlocked, which can act as an air lock to prevent unpurified air from entering the clean area. It is a highly versatile local purification equipment. The air shower room is generally installed between the clean area and the non-clean area, as a passage between the clean room and the non-clean room.