In the process of using the wind chamber, it is sometimes encountered in the wind. The following points are several cases often encountered by daily customers, and the reference can be referred to (1) first check the power switch and Whether the emergency stop switch is on state, if two reasons are not, check the circuit and the leakage switch is closed. (2) Whether the FUSE fuse configured by the IC board is blown, such as the fuse of the fuse, the 4A fuse is required. (3) Check if the micro switch and the photoelectric switch move, if there is no action, the micro switch and photoelectric switch should be replaced. (4) If the AC contactor does not work, it affects the blow, and the AC contactor is required. (5) If the circuit board cannot output a signal in an AC contactor coil, it is necessary to change the IC circuit board. (6) When the wind shower is blowing, it is not allowed to force the door. If the emergency situation is encountered, the shutdown can be turned off. After more than ten years of industry experience, the new environment is always

The clean air blown out of the air shower can remove dust carried by people, and can effectively block or reduce the dust source from entering the clean area. At the same time, the two doors of the air shower room are electronically interlocked, which can act as an air lock to prevent unpurified air from entering the clean area. It is a highly versatile local purification equipment. The air shower room is generally installed between the clean area and the non-clean area, as a passage between the clean room and the non-clean room.

At present, many industries use air shower products, and some purchasers are not very familiar with the specific purpose of the air shower. Today, snyli Purification Editor will do a simple sharing for everyone. The air shower is mainly used in dust-free workshops such as electronics, medical treatment, pharmaceuticals, crystal materials, and food. It is a protective opening for personnel to enter the workshop. After being blown in the air shower room, some debris particles such as dust carried by the personnel will be removed.

The air shower room is highly automated and easy to operate. Some use infrared induction technology to enter from the unclean area. After the door is closed, the infrared sensor will blow the shower. After the shower, the door is locked, and you can only go out of the air shower room. The electronic interlocking of the door can double the effect of the airlock chamber, preventing external pollution and unpurified air from entering the clean area.